Electralog Electric Fireplace Owner's Manual download pdf (Page 9)

9

Operation

minutes before switching the unit

back on.

CAUTION: If you need to

continuously reset the heater,

unplug the unit and call technical

support at 1-888-346-7539.

!

NOTE: The heater may emit

a slight, harmless odor when

rst used. This odor is a normal

condition caused by initial heating

of internal heater parts and will

not occur again.

Remote Control (Figure 3)

The replace is supplied with an

integrated on/off remote control.

!

NOTE: Ensure that the

replace 3 position switch

is set to the remote control

setting (up position).

ON

Button

Battery Cover

OFF

Button

Battery

Figure 3

To operate, push the ON button

to turn replace on, push the OFF

button to turn the replace off.

Remote Control Initialization/

Reprogramming

In the event that your remote

control ceases to operate your

replace, follow these steps to re-

initialize the hand held transmitter

and the remote control receiver in

the replace:

Place the 1. Three Position

Switch (Figure 2A) in the Off (“

O ”) position.

Wait a minimum of ve (5) 2.

seconds and then place the

Three Position Switch in

the Remote Control (“ II ”)

position.

Within3. 10 seconds of

changing the switch position,

press the ON button located

on the remote control

transmitter (Figure 2).

This will synchronize the remote

control transmitter and the

replace receiver.

!

NOTE: You will have only 10

seconds to perform this last step.

Failure to do so will result in these

steps needing to be followed

again.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 46 47

Comments to this Manuals

Bob 07 Jan 2024 | 16:54:45

Air heater parts