Electralog Electric Fireplace Owner's Manual download pdf (Page 7)

7

Installation

Figure 1

Rear Support

Main Body

Mantel Top

Hardware

!

NOTE: A 15 Amp, 120 Volt

alternating current (VAC) circuit

is required. A dedicated circuit

is preferred but not essential in

all cases. A dedicated circuit will

be required if, after installation,

the circuit breaker trips or fuse

blows on a regular basis when the

heater is operating. Additional

appliances on the same circuit

may exceed the current rating of

the circuit breaker.

WARNING: Ensure the power

cord is not installed so that it is

pinched or against a sharp edge

and ensure that the power cord is

stored or secured to avoid tripping

or snagging to reduce the risk

of re, electric shock or injury to

persons.

WARNING: Construction

and electrical outlet wiring must

comply with local building codes

and other applicable regulations

to reduce the risk of re, electric

shock and injury to persons.

WARNING: Do not attempt

to wire your own new outlets or

circuits. To reduce the risk of re,

electric shock or injury to persons,

always use a licensed electrician.

(No assembly required for the

at wall mantel)

Corner Mantel Assembly

Assemble the top of the 1.

mantel to the rear support

using the supplied hardware.

Using the supplied hardware 2.

assemble the top and rear

support assembly to the main

replace body (Figure 1).

Fireplace Installation

Make sure the unit’s Main 1.

ON/OFF switch is switched

OFF (refer to operating

instruction section).

Plug the unit into a 15 Amp, 2.

120 VAC outlet. If the cord

does not reach, you may use

a No. 14 AWG minimum size

extension cord rated for a

minimum of 1875 Watts.

1 2 3 4 5 6 7 8 9 10 11 12 ... 46 47

Comments to this Manuals

Bob 07 Jan 2024 | 16:54:45

Air heater parts